GSI Forum: General Discussion » [SOLVED] Event filter after simulation phase

Home » Fairroot » General Discussion » [SOLVED] Event filter after simulation phase

Show: Today's Messages :: Polls :: Message Navigator

Re: Event filter after simulation phase [message #24817 is a reply to message #24814]

Thu, 23 April 2020 15:11

Mohammad Al-Turany
Messages: 518
Registered: April 2004
Location: GSI, Germany

first-grade participant

From: *dip0.t-ipconnect.de

Hi MG,

MCTrack are controlled by the Stack filter if any (depend if you implement one). The TGeoTrack are only saved if you switch on the Track visualisation option.

The FairMCApplication forces the write of the entry in the tree (FinishEvent), so if you went to skip a whole event you have to process the tree after simulation.

best,

Mohammad

Report message to a moderator

[Message index]

		[SOLVED] Event filter after simulation phase By: MG on Thu, 23 April 2020 14:57
		Re: Event filter after simulation phase By: Mohammad Al-Turany on Thu, 23 April 2020 15:11
		Re: Event filter after simulation phase By: Florian Uhlig on Thu, 23 April 2020 16:02
		Re: Event filter after simulation phase By: MG on Thu, 23 April 2020 18:41
		Re: Event filter after simulation phase By: MG on Fri, 24 April 2020 23:05
		Re: Event filter after simulation phase By: Florian Uhlig on Fri, 24 April 2020 23:39
		Re: Event filter after simulation phase By: Florian Uhlig on Mon, 27 April 2020 08:39
		Re: Event filter after simulation phase By: MG on Sun, 26 April 2020 19:38

Previous Topic:	Add two similar files as friends in the simulation
Next Topic:	Remove hits from removed tracks

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 07 16:39:30 CET 2025

Total time taken to generate the page: 0.00828 seconds