GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Event Generators » PYTHIA6 usage
Re: PYTHIA6 usage [message #23666 is a reply to message #23661] Fri, 22 February 2019 15:15 Go to previous messageGo to previous message
Anna Skachkova is currently offline  Anna Skachkova
Messages: 37
Registered: September 2018
continuous participant
From: *jinr.ru
Dear colleagues,

I found more information about possible launch of PYTHIA simulation from inside Root - fairsoft_may18/tools/root/montecarlo/pythia6.
From the file /src/TPythia6.cxx one can see how one can choose and set the internal PYTHIA parameters about which I was confused.
So one can really call PYTHIA from Root using the presented parameters. The problem is that the presented list of common-blocks is not full and some
very important parameters which allow to run PYTHIA at low PANDA energies are absent (by default it doesn't work). I hope that inserting the missed information could be done in
analogous way as for the other common-blocks. But one have to think how to compile then these all together.

Best regards,
Anna
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: EvtGenDirec/PHOTOS
Next Topic: Large momenta from BOX genarator
Goto Forum:
  


Current Time: Sat Dec 14 08:22:37 CET 2024

Total time taken to generate the page: 0.00996 seconds