GSI Forum: Installation and Compilation

Home » R3BRoot » Installation and Compilation » Physics List change (Physics List change)

Show: Today's Messages :: Polls :: Message Navigator

Re: Physics List change [message #23183 is a reply to message #23181]

Wed, 24 October 2018 13:38

C. A. Douma
Messages: 88
Registered: September 2015
Location: Groningen

continuous participant

From: *kvi-cart.rug.nl

Thank you for this information, Jan.

Where is g4Config.C loaded? I do not see how this macro communicates with run_sim.C.

Can I also add multiple modules to the PHYISICSLIST environment variable?
For example, my VETO physics list uses both ion_inclxx and qscp_bert (and a few more modules).

Is your neutron cross section example how you calculated figure 6.4 in your thesis?
If so, do all of the lines in this figure only use one single physics list module?

Christiaan.

Report message to a moderator

[Message index]

		Physics List change By: C. A. Douma on Tue, 23 October 2018 16:23
		Re: Physics List change By: Jan Mayer on Tue, 23 October 2018 17:31
		Re: Physics List change By: C. A. Douma on Wed, 24 October 2018 13:38
		Re: Physics List change By: Jan Mayer on Wed, 24 October 2018 14:09

Previous Topic:	FairRoot installation error
Next Topic:	FairSoft compilation error

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jul 02 12:20:24 CEST 2025

Total time taken to generate the page: 0.00747 seconds