GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » General » Re-Mapping of SDS SensorIDs
Re-Mapping of SDS SensorIDs [message #21793] Tue, 21 November 2017 17:30 Go to previous message
Stefan Pflueger is currently offline  Stefan Pflueger
Messages: 99
Registered: February 2012
continuous participant
From: *

I want to assign the SensorID's of the Lmd Pixel sensor volumes with a fixed number. Right now the ID's of active volumes are just globally counted and referenced to the volume paths. So depending on which Detectors you load in the simulation first the ID's of the sensors vary. I thought about introducing a remapping function that would take the global sensor ID get the volume path and with that information remap it to some specific sensor ID of the detector (in the case of the lmd sensors 0-399). I did not look deeply, but I could not find any function so far that would allow me to do this. I think this would be needed in a general way (so not only for the sds hits) and should be implemented in the digitization stage. Could anyone comment on this? I would implement this in a general way in the digitization stage. Is this a good idea?

Best regards,
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Initialization Error of Geane using Geant3 (duplicate)
Next Topic: Migration to git
Goto Forum:

Current Time: Wed Jul 24 17:39:39 CEST 2024

Total time taken to generate the page: 0.00755 seconds