GSI Forum: Simulation Issues » Problem with FairMCApplication with R3BRoot on dev-branch

Home » R3BRoot » Simulation Issues » Problem with FairMCApplication with R3BRoot on dev-branch

Show: Today's Messages :: Polls :: Message Navigator

Re: Problem with FairMCApplication with R3BRoot on dev-branch [message #21750 is a reply to message #21745]

Fri, 10 November 2017 09:06

Dmytro Kresan
Messages: 166
Registered: June 2004

first-grade participant

From: *gsi.de

Hello Anna,

I have tested the r3bsim_g4.C macro with re-created geometries, exactly with your software configuration on GSI linux cluster. I can not reproduce your segmentation fault.
Please post here the macro, which you use to create your own target geometry.

Just to be sure. What do you mean by "re-creating" other geometries? Can you post here the commands you have used for that?

Best regards,
Dima

Report message to a moderator

[Message index]

		Problem with FairMCApplication with R3BRoot on dev-branch By: Anna Corsi on Wed, 08 November 2017 15:07
		Re: Problem with FairMCApplication with R3BRoot on dev-branch By: Dmytro Kresan on Fri, 10 November 2017 09:06
		Re: Problem with FairMCApplication with R3BRoot on dev-branch By: Anna Corsi on Mon, 13 November 2017 10:15
		Re: Problem with FairMCApplication with R3BRoot on dev-branch By: Dmytro Kresan on Mon, 27 November 2017 15:22

Previous Topic:	Dynamic cast fails.
Next Topic:	Error in running run_sim.C

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 15 19:13:29 CEST 2026

Total time taken to generate the page: 0.00790 seconds