GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » General » Implementing Software Alignment into PandaROOT
Re: Implementing Software Alignment into PandaROOT [message #21846 is a reply to message #21722] Mon, 27 November 2017 16:10 Go to previous message
Stefan Pflueger is currently offline  Stefan Pflueger
Messages: 99
Registered: February 2012
continuous participant
 From: *specf.him.uni-mainz.de
Hi all,

I have been discussing the alignment study issue a bit on the ROOT forum.

https://root-forum.cern.ch/t/howto-do-alignment-studies-with-tgeo-howto- handle-overlaps/26918

There were two ways to perform the mis-alignment studies:


  1. Actually mis-align the geometry in the simulation: Pros: easy to handle and realistic. Cons: overlaps in the volumes
  2. Mis-alignment of the Digis/Hits/Clusters. Pros: No overlap issue. Cons: Concept of hits vanishing and appearing on different sensors with the mis-alignment cannot be implemented (or its quite complicated). Hence not as realistic


The Alice collaboration has chosen option 1., which also Andrei suggested as a preferred solution.
The biggest task here would be to study the overlaps in detail.

Best regards,
Stefan

[Updated on: Mon, 27 November 2017 16:11]

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Migration to git
Next Topic: PandaRoot on GIT
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Apr 20 17:34:46 CEST 2024

Total time taken to generate the page: 0.01200 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.2.
Copyright ©2001-2022 FUDforum Bulletin Board Software