GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » General » Simulation on Kronos
Simulation on Kronos [message #19333] Thu, 16 June 2016 09:57 Go to previous message
Jennifer Pütz is currently offline  Jennifer Pütz
Messages: 47
Registered: April 2015
Location: FZ Juelich
continuous participant
From: *
Hi everyone,

due to the fact that Prometheus will be shut down at the end of June, I would like to provide you a submit script for Kronos (see attachment). This submit script is similar to the script for Prometheus (~/pandaroot/trunk/source/macro/prod/job_prod.sge). There is no need to change the macros from ~/pandaroot/trunk/source/macro/prod.

The script is easily submited by using the command:

sbatch <prefix> <nevts> <dec-file> <mom>

If you want to run more than one job in parallel, use e.g.

sbatch --array=1-20 <prefix> <nevts> <dec-file> <mom>

To look up the status of your job use

squeue -u <username>
watch squeue -u <username>
(This command updates the window every 2s.)

For further information see also

You can even run a short test job for debugging (max. 20 minutes):

sbatch --partition=debug <prefix> <nevts> <dec-file> <mom>

I hope this is useful for some of you.

Read Message
Read Message
Read Message
Read Message
Previous Topic: Computing infrastructure at GSI changes
Next Topic: Setting target type in master macros
Goto Forum:

Current Time: Sat Nov 27 18:30:59 CET 2021

Total time taken to generate the page: 0.02191 seconds