GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » R3BRoot » Simulation Issues » More track information (Can I get all the track information instead of just the starting point?)
Re: More track information [message #18942 is a reply to message #18940] Mon, 25 January 2016 16:47 Go to previous messageGo to previous message
C. A. Douma is currently offline  C. A. Douma
Messages: 88
Registered: September 2015
Location: Groningen
continuous participant
From: *kvi-cart.rug.nl
Dear Mr. Kresan,

does Geant3 perform a change of trackID every time?

I understand that the change of trackID on every interaction would be a performance kill.
Nevertheless I would like to know if it is possible and how (for example with changes of flags, etc).
Then at least I can choose every time I run a simulation whether I think the
additional information is required or not.

I do not understand your possible solution to set the air as an active volume.
Inside NeuLAND it also happens that there are multiple interactions without
change of trackID. And LandPoint does not offer information about the X, Y, Z
of these interactions, only about the entering and leaving of the track. If only
X, Y, Z of the tracks leaving the cave are stored, how does this help me
in getting the X, Y, Z of every interaction (which is what I like to have)?

Yours sincerely,
Christiaan Douma.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Problem with including targets in simulation
Next Topic: making Target
Goto Forum:
  


Current Time: Thu Mar 28 13:33:35 CET 2024

Total time taken to generate the page: 0.01114 seconds