GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » NUSTAR » NUSTAR PRESPEC » Scattering Angle Cut
Scattering Angle Cut [message #18448] Tue, 01 September 2015 12:16 Go to previous message
a_boso is currently offline  a_boso
Messages: 16
Registered: July 2014
occasional visitor
From: *pd.infn.it
Hello everybody!

Hope everything is going well! Smile

I have a little question for you:

In order to put a "safe Coulex" condition and avoid the nuclear contribution in the Coulex experiments a cut in the scattering angle from the direction before and after the secondary target is needed.

The scattering angle is obtained from position measurements before the target (tracking from TPCs or, in alternative, LYCCA ToF Start detector), in the target (Target DSSSD) and after the target (Wall DSSSD).

At the ACC in Orsay Christian pointed out that the uncertainties in the position measurements may cause a "bias" in the scattering angle estimation; indeed, if I look at the empty frame runs, I see that the distribution is not peaked at 0 degrees, as I may expect, but at a greater angle (see attachment). It looks like a sort of "offset" in the scattering angle.

It is a crucial point in the analysis since this cut decreases, of course, the number of counts in the peak!

Do you know how to take into account this issue? Does anyone of you have the same problem?

Thank you very much!

Alberto
 
Read Message
Read Message
Previous Topic: FRS - TPC Calibrations
Next Topic: AGATA Crystal positions (Look-Up Table)
Goto Forum:
  


Current Time: Wed Jan 16 19:21:57 CET 2019

Total time taken to generate the page: 0.03428 seconds