GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Tracking » Backpropagation in Kalman Filter
icon4.gif  Backpropagation in Kalman Filter [message #18113] Wed, 08 April 2015 14:51 Go to previous message
StefanoSpataro is currently offline  StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino
first-grade participant

From: *to.infn.it
Dear all,
one of the problems of Kalman Filter for secondaries is the backpropagation of the track parameters from the first point of the track to the Interaction Point, before the fit. This back propagation can fail in case of secondaries which are produced far from the IP, decreasing the reconstruction efficiency. For this reason in the past it was suggested to people doing analysis of lambda channels to switch off such back propagation in the PndRecoKalmanTasks of the reco macro.

An update was done, and now track parameters are back propagated of 2 cm before the first hit, to avoid the IP backpropagation. This procedure should be faster, works also for particles not comiing from the IP, it should not fail, and the results for primaries are comparable to the old version.

By default you will use this option automatically just updating your trunk and recompiling. Of course you are free to switch it off (setting a negative distance) and to switch on the IP back propagation, as before.

This change does not affect the PidCorrelator but only the Kalman Filter. This means that you could have the same problem at the pid level and there you should still switch off the back propagation.

 
Read Message icon4.gif
Read Message
Read Message
Read Message
Read Message
Previous Topic: Moving to Genfit2
Next Topic: Small changes to improve efficiency at low momentum
Goto Forum:
  


Current Time: Tue Dec 07 23:05:49 CET 2021

Total time taken to generate the page: 0.02449 seconds