GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » NUSTAR » NUSTAR PRESPEC » AGATA Crystal positions (Look-Up Table)
Re: AGATA Crystal positions (Look-Up Table) [message #18051 is a reply to message #18049] Mon, 23 March 2015 15:17 Go to previous messageGo to previous message
wieland@mi.infn.it is currently offline  wieland@mi.infn.it
Messages: 13
Registered: July 2014
occasional visitor
From: *mi.infn.it
Dear Michael,
thanks for the modification.The x.y targeshift is a test of the few mm is very little and makes very little effect (but it does, so for lineshape measurments it is crucial) to the line shape.
I dont know if the target dssd was aligned to the target. Maybe Plamen knows.

To insert the rotation inside the code is good.
But one has to carefully check if with this rotation the coordinates finaly correspond to the real measurement.

How many degrees ?

We tested 7,7,5,8,5 degree. 7.5 was up to know the best.BUT as written before,
if one is able to check the final coordinates, so we may fix this value.

Oliver
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Scattering Angle Cut
Next Topic: Multihit TDCs in the PreSPEC setup (CAENv1290)
Goto Forum:
  


Current Time: Tue Dec 10 00:03:48 CET 2024

Total time taken to generate the page: 0.00801 seconds