GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » NUSTAR » NUSTAR PRESPEC » AGATA Crystal positions (Look-Up Table)
Re: AGATA Crystal positions (Look-Up Table) [message #18029 is a reply to message #18028] Fri, 20 March 2015 14:05 Go to previous messageGo to previous message
wieland@mi.infn.it is currently offline  wieland@mi.infn.it
Messages: 13
Registered: July 2014
occasional visitor
From: *mi.infn.it
Dear Damian,
the point is not that they have a differnt distance,
(this can be corrected easily, the measured target position of Strachen and the table distance give an offset of approx 1.1 cm in beam direction and 3.6mm in x, which works good for our 2plus)
BUT the point is that they have ALL exactely the same distance !
This looks very much like a CAD or GEANT table, and not like a measurement.
The measured distances are different between each others of up to some cm.
This is only the distance ! So also (surely) the positions may vary, which is worse !
This means, in my opinion, that the table is NOT respecting the real setup !
This can have very big effects.

For this reason i think it is very important to have the correct table.

oliver

[Updated on: Fri, 20 March 2015 14:15]

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Scattering Angle Cut
Next Topic: Multihit TDCs in the PreSPEC setup (CAENv1290)
Goto Forum:
  


Current Time: Sat Oct 12 06:21:38 CEST 2024

Total time taken to generate the page: 0.00943 seconds