GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » NUSTAR » NUSTAR PRESPEC » AGATA Crystal positions (Look-Up Table)
Re: AGATA Crystal positions (Look-Up Table) [message #18023 is a reply to message #18021] Fri, 20 March 2015 08:58 Go to previous messageGo to previous message
Damian Ralet
Messages: 35
Registered: July 2014
Location: Darmstadt
continuous participant
From: *gsi.de
Hi Oliver,

The coordinate measured by the mechanic group might be more precise, but I am not sure if we can use these only.
The CrystalLookupTable allow to orientate the crystal and to position it in the global referential. The position of the crystal center, as given in the table might miss the rotation of the crystal along its z axis.
I think, the table from the mechanic is really useful to make sure that the positions determined by the CrystalLookupTable are good. We just need orientate properly the two coordinate system, and check the position center of each crystal. If this agreed in the 2012 campaign, they should be good as well for 2014.

Cheers,
Damian
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Scattering Angle Cut
Next Topic: Multihit TDCs in the PreSPEC setup (CAENv1290)
Goto Forum:
  


Current Time: Sat Oct 12 06:15:43 CEST 2024

Total time taken to generate the page: 0.00975 seconds