GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Re: FINGER ToF detector [message #17166 is a reply to message #17162] Wed, 13 August 2014 10:12 Go to previous messageGo to previous message
mlcortes is currently offline  mlcortes
Messages: 41
Registered: July 2014
Location: Darmstadt
continuous participant
From: *
Hi Tayfun,

Yes, time_gate is applied to select the peak of the difference between each PMT and a reference, in this case one side Sc41. The processor will check all the combinations of hits and take as a valid hit the first one that is inside the gate. About the hit_cal parameters, you can leave the default values of 0 for the offset and 1 for the slope. This parameters are there to make a fine calibration in case the time of each hit slightly shifts, nevertheless I think is not really necessary, at least in first approximation.
Let me know if you get some results from the Finger time and if you need anything else.

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Welcome
Next Topic: problem with a processor (software-wise)
Goto Forum:

Current Time: Wed May 29 17:37:09 CEST 2024

Total time taken to generate the page: 0.01092 seconds