Home » NUSTAR » NUSTAR PRESPEC » FRS - TPC Calibrations (Position Calibration Issues)
| Re: FRS - TPC Calibrations [message #18300 is a reply to message #18299] |
Wed, 03 June 2015 14:31   |
mlcortes
Messages: 41
Registered: July 2014
Location: Darmstadt
|
continuous participant |
From: *ikp.physik.tu-darmstadt.de
|
|
Hi Tayfun,
In general, each TPC has 4 y outputs and 2 x outputs. You can check it more in detail in the TPC manual. So, with some hope you can still use at least one for each direction. The x and y outputs are the average of those values.
I just now noticed that we may be using different processors, so here I copy my config file:
processor Frs/TpcS41 FRS.TPC
times[0:7] <- FrsTpcCrate.tdc1[0:7]
amplitudes[0:7] <- FrsTpcCrate.adc1[0:7]
fiber <- FrsTpcCrate.tdc1[23]
display x:y 500,-50,50:500,-50,50 in TPCs/TpcS41
display y 500,-50,50 in TPCs/TpcS41
display x 500,-50,50 in TPCs/TpcS41
display xs 500,-50,50 in TPCs/TpcS41
display ys 500,-50,50 in TPCs/TpcS41
# display x_fiber:y_fiber in TPCs/TpcS41
display checksums | gate_checksums 5000,-2000,3000 in TPCs/TpcS41/checksums
end
Here this different outputs are called xs and ys. I think for the processor called StandardTpc (and not TPC), the different xs and ys are called xc and yc.
Taking care about using the correct inputs, can you please try to run this and get the xs and ys? (And also the x vs y for the mask runs)
Liliana
Li^2
|
|
|
|
Current Time: Tue Oct 08 23:11:19 CEST 2024
Total time taken to generate the page: 0.00772 seconds
|
GSI Forum
Search
Help
Members
Login
Home
