GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Analysis » Vertex Fitter in Fast simulation
Re: Vertex Fitter in Fast simulation [message #16376 is a reply to message #16375] Sat, 19 April 2014 14:15 Go to previous messageGo to previous message
Malte Albrecht is currently offline  Malte Albrecht
Messages: 11
Registered: May 2012
occasional visitor
From: *adsl.alicedsl.de
Hi Stefano!

Yes, actually I tried exactly the same in PndFastSim.cxx and I saw that the momentum errors are all set to zero in the covariance matrix, but I did not proceed to the EMC-classes, where you set the dp() correctly now...

OK, I checked out the most recent version and 4C- as well as mass constraint fit are running. Good thing is: When using a mass constraint for e.g. the eta in my channel, I get a needle at the eta-mass (as expected). But the chi2 values are all extremely small (also for 4C-Fit!), which results in a probability of ~0. The pull-distribution is also a needle at 0 (sigma is much too small), so I guess we need to tune the errors a bit?

Best regards and thanks for your efforts!
Malte
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [FIXED] Error in <PndAnaPidCombiner::Apply>
Next Topic: Lambda Lambdabar simulations
Goto Forum:
  


Current Time: Sat Nov 02 20:02:08 CET 2024

Total time taken to generate the page: 0.00901 seconds