GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Analysis » [FIXED] Problems with photon reconstruction in pandaroot
[FIXED] Problems with photon reconstruction in pandaroot [message #15435] Thu, 05 September 2013 10:40 Go to previous message
Elisabetta Prencipe (2) is currently offline  Elisabetta Prencipe (2)
Messages: 214
Registered: February 2013
first-grade participant
From: *ikp.kfa-juelich.de
Dear all,

I would like to point you on a problem which I have found in the past weeks, using pandaroot, in the photon reconstruction.

When I try to reconstruct a decay chain to charged particles, basically the macro runs and delivers *reasonable* results.

Recently I tried to reconstruct 3 mesons of the DsJ family:
Ds2535+, Ds2460+, Ds2317+.

In the decay chain of Ds2371+ there is only one pi0(-->gamma gamma); the reconstruction is going very slow, but in the end I managed to run my analysis macro over 5000 generated events. It took many hours (~70 h), and in the end the memory used was going up to to 70%...so to split 5000 events in 1000-event-jobs help; but this is not a solution, in my opinion. It has been a warning that something in the photon reconstruction has not worked properly. Of course, I can run in parallel 5 jobs of 1000 events each one, and in ~7-8 hours I get ready my root files and merge them.

In the decay chain of Ds2460+, 3 photons got involved, as we have a pi0 (-->gamma gamma) and a photon in the decay of Ds*+. The decay chain is written on the top of the macro which I attach here.
In this macro I commented out all kinematic fit, mass constrained fit, combinatorial: I am just trying to reproduce the full truth matched value of the invariant mass distributions and the momentum of the particles. Very easy. What comes out is that I can run this macro only up to 10 events (--->36% memory used). When I try to run 15 events, the memory grows abnormal up to 80% in a few seconds, and then my job is stopped after 20 seconds. It is not possible for me to reconstruct more than 10 events for the decay chain of the Ds2460+ right now, in the main decay of interest, just because it involves 3 photons. Here definitively something is going wrong with photon reconstruction, because when I tried to reconstruct the Ds2460+ only to charged particles, it worked smooth.

Did anybody of you tried to reconstruct a decay channel where more than 2 photons got involved? If yes, what is your experience?

I am using pandaroot rev-21003.

Thank you in advance for any feedback,
Elisabetta

[Updated on: Sun, 08 September 2013 12:04] by Moderator

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [FIXED] Recontruction of neutrals - macro is very slow
Next Topic: Rho package update - rev 21551 - problem
Goto Forum:
  


Current Time: Tue Dec 10 15:00:05 CET 2024

Total time taken to generate the page: 0.00753 seconds