GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » Hades » Pluto » [CLOSED] Turning ON/OFF Models
[CLOSED] Turning ON/OFF Models [message #13290] Tue, 03 April 2012 19:57 Go to previous message
Michael Kunkel is currently offline  Michael Kunkel
Messages: 53
Registered: June 2011
continuous participant
From: 129.57.114*
Greetings again,

I use PLUTO for simulating eta dalitz decays produced via photoproduction on a liquid hydrogen target (gamma p -> p eta [e+e-gamma]). I ensure that I use a beam profile of a 1/E(gamma) in the simulation, however the reconstructed parameters do not match the data.

So what I would like to do is use the data itself as the initial parameters and have PLUTO decay the eta via dalitz decay, ie event by event use the parameters:
Photon Beam Energy (0, 0, E, E)
Target
Proton "myproton = P3M(px,py,pz,mass);"
Eta "myEta = P3M(etapx,etapy,etapz,etamass);"
then use
PReaction my_reaction("Beam_Energy","g","p","myproton myeta [dilepton [e+ e-] g]","eta_data_simulate",1,0,0,0);


Is it possible, since these variables are from data, to only have the eta dalitz physics operational when running PLUTO?

Thanks
Michael

[Updated on: Wed, 22 May 2013 12:38] by Moderator

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Some comments on the rho->ee decay
Next Topic: [SOLVED] Beam Smearing
Goto Forum:
  


Current Time: Thu Dec 05 23:33:56 CET 2024

Total time taken to generate the page: 0.00710 seconds