GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Bugs, Fixes, Releases » D+ and D- vertex resolution from Psi analysis
Re: D+ and D- vertex resolution from Psi analysis [message #12294 is a reply to message #12292] Tue, 19 July 2011 13:14 Go to previous messageGo to previous message
donghee is currently offline  donghee
Messages: 385
Registered: January 2009
Location: Germnay
first-grade participant
From: *
Hi Stefano,

I have done it with may11 release version based on v12414.
After switching off ISR photons, you produced run 800 and 800np series with may11.
I didn't see any psi production for those series.
Therefore I decided to produce some data with STT mode, since STT seemed to be stable at that time (just I thought like that)

Then, I copy the scripts from pbarprod/tdr11/macros/psi3770.
and produced psi with STT mode.

So, The data, what I shown you, is corresponding 8XXnp data production with may11.
If something changed during last week even at STT part, then I can get feeling that possible improvement will be come with july11 version.

I will test it with latest version of pandaroot again.

If I used same code, which is existed in Gridka, then MVD was used automatically.

And you mentioned about the bad resolution of psi3770 with 6 final states.

I think this is a matter of implementation of the analysis macro.

I think this is a matter of reconstruction of production macro
due to the fact of all resolution strongly depends on good quality of track reconstruction.

Best regards,

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Number of entries in TTree
Next Topic: Pandaroot version 12806 Crash
Goto Forum:

Current Time: Tue Jun 25 20:47:05 CEST 2024

Total time taken to generate the page: 0.01177 seconds