GSI Forum: Bugs, Fixes, Releases » Error and warning in geometry of MDT and DRC

Home » PANDA » PandaRoot » Bugs, Fixes, Releases » Error and warning in geometry of MDT and DRC

Show: Today's Messages :: Polls :: Message Navigator

Re: Error and warning in geometry of MDT and DRC [message #11709 is a reply to message #11706]

Thu, 21 April 2011 16:07

donghee
Messages: 385
Registered: January 2009
Location: Germnay

first-grade participant

From: *kph.uni-mainz.de

I have same message...
I assume that one can simply ignore it, because this geometry is only part of DRC and should not change results too much in the tracking level.
But I'm not sure for PID part....will give some small(?) effects.
However, in simulation I don't have any crash due to that.

Quote:

====================================================
======= DRC:: ConstructOpticalGeometry() ========
Warning in <TGeant3TGeo::DefineOpSurface>: Called for surface BarSurface. Not applicable in Geant3 - setting is ignored.
Warning in <TGeant3TGeo::SetBorderSurface>: Called for border surface BarAirSurface. Not applicable in Geant3 - setting is ignored.

Report message to a moderator

[Message index]

		Error and warning in geometry of MDT and DRC By: Olaf Hartmann on Thu, 21 April 2011 15:55
		Re: Error and warning in geometry of MDT and DRC By: donghee on Thu, 21 April 2011 15:58
		Re: Error and warning in geometry of MDT and DRC By: Olaf Hartmann on Thu, 21 April 2011 16:04
		Re: Error and warning in geometry of MDT and DRC By: donghee on Thu, 21 April 2011 16:07
		Re: Error and warning in geometry of MDT and DRC By: Maria Patsyuk on Sun, 01 May 2011 12:09

Previous Topic:	Gas mixture composition (WMAT).
Next Topic:	Configuring incomplete, errors occurred trunk

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jul 20 01:46:18 CEST 2025

Total time taken to generate the page: 0.00765 seconds