Home » PANDA » PandaRoot » General » Problem with Root geometrys from CAD
Re: Problem with Root geometrys from CAD [message #10908 is a reply to message #10633] |
Fri, 06 August 2010 13:45 |
Christian Hammann
Messages: 24 Registered: July 2009 Location: Bonn
|
continuous participant |
From: *cb.uni-bonn.de
|
|
Hi all
I have still have not been able to find a solution for this problem. However as it seems to be working with geant3 I have commited the code for the proto60 to svn, rev. 9625, along with a geometry for the proto60. At the moment only the crystals are included, no alveoles etc.
The geometry uses geometry version 18, mapperversion 10, module 7.
Regards
Christian
Christian Hammann
Universität Bonn
Helmholz-Institut für Strahlen und Kernphysik
Nußallee 14-16
53115 Bonn
Tel: +49 228 733895
Fax: +49 228 732505
|
|
|
Goto Forum:
Current Time: Sat Nov 09 10:34:30 CET 2024
Total time taken to generate the page: 0.00869 seconds
|