GSI Forum: Monte Carlo Engines » Geant4: problem with set seed and cuts

Home » PANDA » PandaRoot » Monte Carlo Engines » Geant4: problem with set seed and cuts

Show: Today's Messages :: Polls :: Message Navigator

Re: Geant4: problem with set seed and cuts [message #9580 is a reply to message #9516]

Mon, 19 October 2009 12:29

Jerome Boucher
Messages: 11
Registered: October 2008
Location: IPNO

occasional visitor

From: *kph.uni-mainz.de

Hi!

Sorry for the late answer, I was fighting with my laptop...

I tried the gRandom->SetSeed(seed) with the revision you specified but it seems that there is no effect.
I added a line in the g4Config.C to print out the buffer and it is correctly filled.

best regards
jerome

Report message to a moderator

[Message index]

		Geant4: problem with set seed and cuts By: Jerome Boucher on Tue, 06 October 2009 13:52
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Wed, 07 October 2009 16:58
		Re: Geant4: problem with set seed and cuts By: Jerome Boucher on Thu, 08 October 2009 10:54
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Thu, 08 October 2009 11:15
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Thu, 08 October 2009 17:22
		Re: Geant4: problem with set seed and cuts By: Dmitry Khaneft on Fri, 09 October 2009 13:47
		Re: Geant4: problem with set seed and cuts By: Jerome Boucher on Mon, 19 October 2009 12:29

Previous Topic:	GEANT3: of energy loss and delta rays
Next Topic:	elastic neutron scattering in Geant3

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Jul 07 18:03:00 CEST 2025

Total time taken to generate the page: 0.00495 seconds