GSI Forum: Monte Carlo Engines » Geant4: problem with set seed and cuts

Home » PANDA » PandaRoot » Monte Carlo Engines » Geant4: problem with set seed and cuts

Show: Today's Messages :: Polls :: Message Navigator

Re: Geant4: problem with set seed and cuts [message #9536 is a reply to message #9535]

Thu, 08 October 2009 11:15

Mohammad Al-Turany
Messages: 518
Registered: April 2004
Location: GSI, Germany

first-grade participant

From: *gsi.de

Hi,

This comes because the concept of cuts in G3/G4 is different, in VMC these cuts are tracking cuts, they are there to make it possible to compare the results of G3/G4.

In the new release of VMC you can also apply them to G4 and they can behave more or less like the G3 one and then you will see also the difference in the output.

regards

Mohammad

Report message to a moderator

[Message index]

		Geant4: problem with set seed and cuts By: Jerome Boucher on Tue, 06 October 2009 13:52
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Wed, 07 October 2009 16:58
		Re: Geant4: problem with set seed and cuts By: Jerome Boucher on Thu, 08 October 2009 10:54
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Thu, 08 October 2009 11:15
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Thu, 08 October 2009 17:22
		Re: Geant4: problem with set seed and cuts By: Dmitry Khaneft on Fri, 09 October 2009 13:47
		Re: Geant4: problem with set seed and cuts By: Jerome Boucher on Mon, 19 October 2009 12:29

Previous Topic:	GEANT3: of energy loss and delta rays
Next Topic:	elastic neutron scattering in Geant3

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 17 05:25:16 CEST 2026

Total time taken to generate the page: 0.00904 seconds