GSI Forum: Monte Carlo Engines » Geant4: problem with set seed and cuts

Home » PANDA » PandaRoot » Monte Carlo Engines » Geant4: problem with set seed and cuts

Show: Today's Messages :: Polls :: Message Navigator

Re: Geant4: problem with set seed and cuts [message #9539 is a reply to message #9516]

Thu, 08 October 2009 17:22

Mohammad Al-Turany
Messages: 518
Registered: April 2004
Location: GSI, Germany

first-grade participant

From: *gsi.de

Hallo,

I just modified the g4Config.C in a way that G4 use by default the values you set in gRandom in your simulation macro. (svn r 6707) so from this release it is not needed any more to change the g4config.in or use the previous way described in this forum. G4/G3 use the same seed from gRandom.

regards

Mohammad

Report message to a moderator

[Message index]

		Geant4: problem with set seed and cuts By: Jerome Boucher on Tue, 06 October 2009 13:52
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Wed, 07 October 2009 16:58
		Re: Geant4: problem with set seed and cuts By: Jerome Boucher on Thu, 08 October 2009 10:54
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Thu, 08 October 2009 11:15
		Re: Geant4: problem with set seed and cuts By: Mohammad Al-Turany on Thu, 08 October 2009 17:22
		Re: Geant4: problem with set seed and cuts By: Dmitry Khaneft on Fri, 09 October 2009 13:47
		Re: Geant4: problem with set seed and cuts By: Jerome Boucher on Mon, 19 October 2009 12:29

Previous Topic:	GEANT3: of energy loss and delta rays
Next Topic:	elastic neutron scattering in Geant3

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jul 05 07:33:44 CEST 2025

Total time taken to generate the page: 0.00777 seconds