GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » General » Lumi position in x-y plane
Re: Lumi position in x-y plane [message #9105 is a reply to message #9102] Thu, 30 July 2009 09:42 Go to previous messageGo to previous message
donghee is currently offline  donghee
Messages: 385
Registered: January 2009
Location: Germnay
first-grade participant
From: *kph.uni-mainz.de
Dear Colleagues,

I have tested the possible detection rate of Lumi-monitor.
Some box generator produced anti-proton particle with following condition
Quote:


boxGen->SetPRange(14, 15);
boxGen->SetPhiRange(0.,360.);
boxGen->SetThetaRange(0.001, 1.0);



I required coincidance hits in each 4 station at Lumi as suggested in Lumi macro.
And I have scan the three different theta range with 0.001-0.2, 0.2-0.4, 0.4-0.6 degree. Finally I have got the number of reconstructed event in Lumi.

Set 1. ( 0.001-0.2 degree) 652(reconstructed in Lumi) / 10000(generated)
Set 2. ( 0.2 - 0.4 degree) 1425(reconstructed in Lumi) / 10000(generated)
Set 3. ( 0.4 - 0.6 degree) 72(reconstructed in Lumi) / 10000(generated)

This number shows us that the Lumi-monitor detection rate is quite poor and not so efficient in current setup!
And allowing theta acceptance is less then 0.4 degree! (need more fine bin to see precise limit)
Delta theta(MC-reco) plot is attached for data set2.

I found that Lumi is located x=0, y=0, z=10.5-12.5m without considering bending magent, therefore it has x=0, y=0 position now, and beam pipe is also designed as straight line.
This is not realistic position, if you want to test lumi with forward bending magnet. Is the geometry and location updated during last 2-3 weeks?

If you have some comment, would be helpful!
Thank you,
Donghee







  • Attachment: z_2.eps
    (Size: 11.02KB, Downloaded 208 times)
 
Read Message
Read Message
Read Message
Previous Topic: unit of energy in Lumi monitor reconstruction
Next Topic: make -jN for external packages
Goto Forum:
  


Current Time: Fri Mar 29 16:59:32 CET 2024

Total time taken to generate the page: 0.01396 seconds