GSI Forum: EMC » forward endcap quest goes on

Home » PANDA » PandaRoot » EMC » forward endcap quest goes on

Show: Today's Messages :: Polls :: Message Navigator

Re: forward endcap quest goes on [message #8680 is a reply to message #8667]

Tue, 26 May 2009 23:04

Bertram Kopf
Messages: 110
Registered: March 2006

continuous participant

From: *pools.arcor-ip.net

Hi Irina,
the electromagnetic shower starts in general not directly at the front face of the crystals. Therefore the reconstruction takes a certain shower depth of a few cm into account. This could cause the inconsistencies in the position between the EmcHits, EmcDigis and the EmcRecoHits.
Please check, if your obtained shifts are comparable with the offset used for the calculation of the digi- and reco-hit position.

Cheers,
Bertram.

Report message to a moderator

[Message index]

		forward endcap quest goes on By: Irina Brodski on Fri, 22 May 2009 14:56
		Re: forward endcap quest goes on By: Irina Brodski on Tue, 26 May 2009 15:21
		Re: forward endcap quest goes on By: Irina Brodski on Tue, 26 May 2009 16:51
		Re: forward endcap quest goes on By: Bertram Kopf on Tue, 26 May 2009 23:04
		Re: forward endcap quest goes on By: Irina Brodski on Tue, 26 May 2009 23:58
		Re: forward endcap quest goes on By: Aleksandra Biegun on Wed, 10 June 2009 16:58
		Re: forward endcap quest goes on By: Irina Brodski on Wed, 10 June 2009 21:03
		Re: forward endcap quest goes on By: Aleksandra Biegun on Thu, 02 July 2009 15:57
		Re: forward endcap quest goes on By: Irina Brodski on Wed, 08 July 2009 12:45
		Re: forward endcap quest goes on By: mpeliz on Wed, 08 July 2009 14:58
		Re: forward endcap quest goes on By: Aleksandra Biegun on Thu, 09 July 2009 11:22
		Re: forward endcap quest goes on By: StefanoSpataro on Thu, 09 July 2009 11:24
		Re: forward endcap quest goes on By: Aleksandra Biegun on Thu, 09 July 2009 15:43

Previous Topic:	Mass calculation from vector<PndEmcDigi*> in EMC
Next Topic:	Question about emc crystal numbering

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jan 21 11:40:33 CET 2026

Total time taken to generate the page: 0.00664 seconds