GSI Forum: EMC » Mass calculation from vector<PndEmcDigi*> in EMC

Home » PANDA » PandaRoot » EMC » Mass calculation from vector<PndEmcDigi*> in EMC

Show: Today's Messages :: Polls :: Message Navigator

Re: Mass calculation from vector<PndEmcDigi*> in EMC [message #8600 is a reply to message #8599]

Wed, 20 May 2009 11:23

Dima Melnychuk
Messages: 213
Registered: April 2004
Location: National Centre for Nucle...

first-grade participant

From: *fuw.edu.pl

Dear Donghee,

I can try to answer to your question but I hope that Bertram will correct me if I am wrong.

So first of all as I understand "invariant shower mass" should not give you a real mass of a particle but is just a property of the shower that allow you discriminate clusters from real photons and cluster which are created by two photons from pi0 decay.
From this point of view it does not make sense to apply the energy correction to calculate mass of the cluster. The energy correction does make sense if the particle if identified already as a photon.

Second, I want to add a comment what the clusters and digis are. The digi is in principle an energy deposited in single crystal, smeared somehow with electronic response. PndEmcMakeCluster task find a group of neighbor crystals and create from them a cluster and energy of the cluster is a sum of the energies of digis which it is made from.

May be you can look into my short presentation from the last EVO meeting ( http://panda-wiki.gsi.de/pub/Computing/Minutes13May2009/D.MelnychukPndEm cCluster130509.pdf), where I summarized a little bit about EmcClusters, however this presentation was for slightly different purpose.

Best regards,
Dima

Report message to a moderator

[Message index]

		Mass calculation from vector<PndEmcDigi*> in EMC By: donghee on Tue, 19 May 2009 13:51
		Re: Mass calculation from vector<PndEmcDigi*> in EMC By: Bertram Kopf on Tue, 19 May 2009 17:18
		Re: Mass calculation from vector<PndEmcDigi*> in EMC By: donghee on Wed, 20 May 2009 08:53
		Re: Mass calculation from vector<PndEmcDigi*> in EMC By: Dima Melnychuk on Wed, 20 May 2009 11:23
		Re: Mass calculation from vector<PndEmcDigi*> in EMC By: Bertram Kopf on Wed, 20 May 2009 11:58
		Re: Mass calculation from vector<PndEmcDigi*> in EMC By: donghee on Wed, 20 May 2009 12:18
		Re: Mass calculation from vector<PndEmcDigi*> in EMC By: Bertram Kopf on Wed, 20 May 2009 13:53

Previous Topic:	Question about GetEnergyCorrected()
Next Topic:	forward endcap quest goes on

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Feb 18 18:17:53 CET 2026

Total time taken to generate the page: 0.00921 seconds