GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » EMC » Question about GetEnergyCorrected()
Re: Question about GetEnergyCorrected() [message #8555 is a reply to message #8553] Thu, 14 May 2009 11:22 Go to previous messageGo to previous message
Dima Melnychuk is currently offline  Dima Melnychuk
Messages: 213
Registered: April 2004
Location: National Centre for Nucle...
first-grade participant
From: *fuw.edu.pl
Hi Donghee,

This correction takes into account energy losses due to leakage and energy thresholds for single crystal - 3 MeV.

It is roughly 3 %, but is dependent on energy and theta angle.

The correction implemented in GetEnergyCorrected() function is ported from the old framework and should be redone in pandaroot (since different version of Geant4 are used) but it still roughly do the job.

And in principle it should be latter replaced by the calibration for example on pi0 or eta mass, but this part of software is still missing.

Best regards,
Dima
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Possible optimization of EMC data classes
Next Topic: Mass calculation from vector<PndEmcDigi*> in EMC
Goto Forum:
  


Current Time: Thu Mar 28 10:30:47 CET 2024

Total time taken to generate the page: 0.01728 seconds