GSI Forum: General » Multiple scattering model in GEANT3

Home » CBM » CBMROOT » General » Multiple scattering model in GEANT3

Show: Today's Messages :: Polls :: Message Navigator

Re: Multiple scattering model in GEANT3 [message #13198 is a reply to message #8439]

Tue, 13 March 2012 20:47

Christian Simon
Messages: 1
Registered: March 2010

occasional visitor

From: *physi.uni-heidelberg.de

Do I get it right that setting

gMC->SetProcess("MULS",1); to
gMC->SetProcess("MULS",0);

in "gconfig/SetCuts.C" is the only change I need to make in order to run a CBMroot (JUN11) simulation (e.g. "macro/run/run_sim.C") without multiple scattering, using Geant3?

Report message to a moderator

[Message index]

		Multiple scattering model in GEANT3 By: Volker Friese on Wed, 06 May 2009 12:34
		Re: Multiple scattering model in GEANT3 By: Claudia Höhne on Wed, 06 May 2009 12:51
		Re: Multiple scattering model in GEANT3 By: Mohammad Al-Turany on Sun, 17 May 2009 22:37
		Moliere is default in G3 By: Volker Friese on Mon, 18 May 2009 16:02
		Re: Multiple scattering model in GEANT3 By: Christian Simon on Tue, 13 March 2012 20:47
		Re: Multiple scattering model in GEANT3 By: Volker Friese on Wed, 14 March 2012 18:57

Previous Topic:	Coordinate system for hit parameters
Next Topic:	New external packages release sep12

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 22 15:02:33 CEST 2025

Total time taken to generate the page: 0.00884 seconds