Home » PANDA » PandaRoot » General » Simulation crashes after "singular matrix" in digitization macro
| Simulation crashes after "singular matrix" in digitization macro [message #9321] |
Fri, 04 September 2009 14:16  |
Christian Leitold
Messages: 35
Registered: August 2009
Location: Stefan Meyer Institute
|
continuous participant |
From: *smi.oeaw.ac.at
|
|
Hello,
I have discovered a serious problem in our full simulation: So far, in the last few days I have only done short simulations with a limited number of events, never more than about 50. Now, after doing a little bit more, I was very surprised that the simulation suddenly crashed. I think the reason is in some way to related to an error in the digitization run:
DIGI EXECUTION *********************
Hit array contains 56 hits
PndEmcMakeCluster, event: 81
***************** PndEmcMakeBump, event: 81 **************
Digi at (250, 262) was a local max. Energy = 0.822928
Digi at (248, 281) was a local max. Energy = 0.260981
Digi at (234, 249) was a local max. Energy = 0.507599
EMC header: fired crystals= 56, digi= 31, Total energy= 2.13144 [GeV], Reconstru
cted clusters= 4, Total energy in clusters= 2.10211 [GeV]
-I- PndSttTrackFinderIdeal: all 114, acc. 1, rec. 1
-I- PndSttMatchTracks: rec. 1, quota 100 %
FIT xy ********************
hitcounter: 8
Error in <TDecompLU::DecomposeLUCrout>: matrix is singular
-E- pre prefit FAILED 0 24.8538
-I- PndSttHelixHitProducer: 0 track 8 SttHits, 8 HelixHits created.
----------------------------------------
This is followed by fitter exceptions and errors in the Kalman task:
FitterException thrown with excString:
findpca failure
in line: 354 in file: /home/cleitold/pandaroot/fairsoft/trunk/trackrep/GeaneTrac
kRep.cxx
with fatal flag 0
FitterException Info Output
*** S/R ERPROP IERR = 2
*** Error in subr. TRPROP 2 called bysubr. ERPROP
And then I end up with a tcands.root that does not contain a cbmsim tree. The problem occurs as soon as I do a simulation with about 80 to 100 events, even though it might not occur every time I run the simulation, so I suspect there might be a certain per-event probability for it.
Any ideas how to get rid of that kind of problems?
Thanks
Christian
[Updated on: Fri, 04 September 2009 14:16] Report message to a moderator |
|
|
|
Current Time: Sat Apr 20 01:34:27 CEST 2024
Total time taken to generate the page: 0.01113 seconds
|
GSI Forum
Search
Help
Members
Login
Home
