GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » Alice » Alice TRD Software » Raw data read and write
Re: Raw data read and write [message #3846 is a reply to message #3840] Wed, 06 December 2006 18:17 Go to previous messageGo to previous message
Ken Oyama is currently offline  Ken Oyama
Messages: 7
Registered: November 2006
Location: Heidelberg
occasional visitor
From: *
Hi Christian, and all,

Adding TRAP pedestal of 10 might be enough if we do it

What will be different from real case is
that if ADC intrinsic pedestal is large (like 100),
we loose dynamic range of 10 % because ADC range is
limited from 0 to 1023.
This feature can not be simulated if we add 10.
It seems designer of current digitizer was thinking
about this effect as far as I see from the code.

This problem is relevant only if there is huge signal.
I do not know this affects to tracking performance.
Maybe it is negligible. Does anybody know?

If we decide such effect is negligible and do not care
then I would just put 10 (actually it was done!).

best regards,


Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Next Topic: alignment
Goto Forum:

Current Time: Mon Jul 22 23:19:34 CEST 2024

Total time taken to generate the page: 0.00802 seconds