GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » Fairroot » General Discussion » How can I add particles to the simulation after a particle was stopped?
Re: How can I add particles to the simulation after a particle was stopped? [message #26151 is a reply to message #26150] Thu, 08 December 2022 18:03 Go to previous message
m.steinen is currently offline  m.steinen
Messages: 3
Registered: December 2022
occasional visitor
From: *specf.him.uni-mainz.de
Solved the problem (hopefully). Had to set the "stackPopper" special process in g4config.C.
Found this here: https://root-forum.cern.ch/t/stack-pushtrack-in-vmc/20986
 
Read Message
Read Message
Previous Topic: Visualization of trajectories from simulation
Goto Forum:
  


Current Time: Thu Mar 28 16:47:45 CET 2024

Total time taken to generate the page: 0.03835 seconds