GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » Alice » Alice TRD chamber construction » New passivation epoxy?
Re: New passivation epoxy? [message #2388 is a reply to message #2386] Wed, 05 October 2005 15:34 Go to previous message
Clemens Adler is currently offline  Clemens Adler
Messages: 42
Registered: March 2004
continuous participant
From: *physi.uni-heidelberg.de
Hello,
I got a sample of AY103/HY991 from the HE group here at Heidelberg and was just playing around a bit with it. I would say in terms of viscosity the glue is fine. I would actually even prefer it to the AW 106. The glue flows, but it has enoug surface tension that is stays e.g. on a ledge without flowing down. So I think it would also be fine for gluing anode wires.
The HE group in fact fills the glue with some silica so that it becomes more thixotrope. So this might be a possibility in case the viscosity turns out to be a problem, but I think it would be OK as it is.
From the datasheet I learned that the shear strength is 30% lower than for AW106, but this might also not hurt us. And the curing time is a bit longer, but below 24h, so I would also say that this is acceptable. So let's see what some more tests show...

cheers,
Clemens
 
Read Message icon5.gif
Read Message
Previous Topic: New Hardener
Goto Forum:
  


Current Time: Wed Aug 23 23:24:02 CEST 2017

Total time taken to generate the page: 0.02430 seconds