GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » R3BRoot » Data Analysis » Channel / Crystal / Bar / Detector numbers
Re: Channel / Crystal / Bar / Detector numbers [message #18983 is a reply to message #18981] Fri, 05 February 2016 09:21 Go to previous messageGo to previous message
Ralf Plag is currently offline  Ralf Plag
Messages: 25
Registered: September 2015
continuous participant
From: *hsi13.unitymediagroup.de
Hi Dima,

right, they should not appear in final plots, but whenever you look at a cbmsim-Tree, they appear.
I have no preference, I only think we should stick to a standard to keep the confusion at a minimum level.

The output of ucesb depends on the mapping, so there we have the choice. As I have seen so far, channel numbers are 1-based there.
land02 was actually quite clever and automatically added +1 to channel numbers when writing into a TTree. So they were 0-based in the code and 1-based for the user in the TTree.

How is it done for Neuland, Califa, and others?

Cheers,
Ralf
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Data levels in R3Broot - suggestion
Next Topic: Ascii calib files
Goto Forum:
  


Current Time: Wed Feb 28 11:37:53 CET 2024

Total time taken to generate the page: 0.01037 seconds