GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Analysis » Panda target and vertex cuts
Re: Panda target and vertex cuts [message #18591 is a reply to message #18584] Wed, 28 October 2015 09:30 Go to previous messageGo to previous message
Klaus Götzen is currently offline  Klaus Götzen
Messages: 293
Registered: June 2006
Location: GSI
first-grade participant
From: *gsi.de
Hi,


the PhD thesis indeed indicates, that the reactions come from this overlap volume with diameter 1.6mm (+-1 sigma region) in x,y directions and 3mm in z (thickness of the pellet stream). The integral of this 2-D gaussian in x,y between -2...2mm in both directions is something like 97%, which seems to be quite robust against small shifts of the center point (i.e. how well we know the absolute position of this volume in space, which depends on alignment). A shift of 1mm in both x and y still gives P=80%.

-> Your cut of +-2mm around (0,0,0) for the pellet target case might be fine I guess.

Concerning the cluster jet, you can take a look at p. 30, Fig. 5.8 in Target TDR (https://panda.gsi.de/oldwww/archive/TargetTDR/Targets_TDR.pdf). There is reported about a fermi like density function with a diameter of about 12-14mm. This would refer only to the spread in z-direction, so that you in that case can apply a tight cut only on the vertex distance to the z-axis, perhaps combined with a rather wide cut on the vertex z-position.


Best,
Klaus
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Using Rho without MC info
Next Topic: electron reconstruction in pandaroot
Goto Forum:
  


Current Time: Tue Mar 19 09:02:37 CET 2024

Total time taken to generate the page: 0.00985 seconds