GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Analysis » hyperon fast simualtions
Re: hyperon fast simualtions [message #16583 is a reply to message #16552] Mon, 12 May 2014 17:38 Go to previous message
Karin Schönning
Messages: 65
Registered: August 2012
Location: Uppsala University
continuous participant
From: *physics.uu.se
OK, I see. I ran some simulations for Lambda Lambdabar at 1.64 GeV/c and 4 GeV/c (with fastsim_opt), and got the following LLbar efficiencies with the different setups in the fast sim:

1.64 GeV/c:

Full: 4.2%
No FS: 3.6%
No Barrel EMC: 4.4%
No MVD/GEM: 0.6%

4 GeV/c:

Full: 4.7%
No FS: 0.8%
No Barrel EMC: 5.0%
No MVD/GEM: 1.5%

some remarks/question marks:

1: The efficiency for the full setup in fastsim is smaller than for the full simulations, which means that the numbers should be taken with a grain of salt. Maybe the relative numbers are relevant though.
2: The efficiency without EMC barrel is slightly better than for the full setup. The difference is within the statistical uncertainty but if the difference remains after running more events (ran only 10000 so far for each case) what could be the reason? As far as I know, the particles are anyway reconstructed before entering the EMC so it shouldn't be because some particles are absorbed by the EMC, right?
3: At low energies, MVD and GEMs are necessary for lambda lambdabar studies.
4. At higher energies, both MVD, GEMs and FS are necesary.

Cheers,
/Karin
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Differences between Histo and Ntuple
Next Topic: McTruthMatch problems
Goto Forum:
  


Current Time: Tue Mar 19 03:22:18 CET 2024

Total time taken to generate the page: 0.01203 seconds