GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Analysis » Lambda Lambdabar simulations
Re: Lambda Lambdabar simulations [message #16361 is a reply to message #16359] Thu, 17 April 2014 17:34 Go to previous messageGo to previous message
Klaus Götzen is currently offline  Klaus Götzen
Messages: 293
Registered: June 2006
Location: GSI
first-grade participant
From: *dip0.t-ipconnect.de
Hi,


I'd like to add some point to the current discussion: Since the tracking detectors in Fast Sim only check for a certain theta region computed from the IP, the acceptance might be wrong for particles coming from displaced vertices. This is due to the fact, that a quite far displaced vertex in radial direction in reality could still be detected with a much smaller theta then that one calculated by connecting the detector edge with the IP. The other way around is also possible: a particle coming from a displaced vertex with large z position could miss the detector even with a theta value being in the acceptance range.

To overcome this limitation, one would need many more geometry parameters for each detector, therefore it was not taken into the initial design of the Fast Sim.


Best,
Klaus
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Vertex Fitter in Fast simulation
Next Topic: [FIXED] Problems with analysis: PidAlgoMvd not found in Tree
Goto Forum:
  


Current Time: Sat Oct 05 16:44:21 CEST 2024

Total time taken to generate the page: 0.00883 seconds