GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Analysis » [FIXED] Problems with photon reconstruction in pandaroot
Re: Problems with photon reconstruction in pandaroot [message #15449 is a reply to message #15447] Thu, 05 September 2013 16:54 Go to previous messageGo to previous message
Elisabetta Prencipe (2) is currently offline  Elisabetta Prencipe (2)
Messages: 214
Registered: February 2013
first-grade participant
From: *ikp.kfa-juelich.de
Hello Klaus,

thank you to take care of this, too.

I updated my Rho package to the revision 21598. Without using any mass selection for the ftm_block, I get a little improvement in the percentage of memory used, but I do not manage to run neither 100 events.

If I apply some basic selection cuts, such as the maximum number of photons per event (e.g., I fix gammas.GetLength()<50) and/or on the momentum of the photons (not smaller than 100 MeV/c), of course I get much Much less entries per event. But I am stacked still in problems of memory leaks, here. Would you please share your test-macro with me, so I can try myself and see how you set up the RhoSelectors for the energy, momentum, number of photon per event? Thank you very much for your help,

Elisabetta
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [FIXED] Recontruction of neutrals - macro is very slow
Next Topic: Rho package update - rev 21551 - problem
Goto Forum:
  


Current Time: Sun Feb 24 03:57:55 CET 2019

Total time taken to generate the page: 0.02285 seconds