GSI Forum: Alice TRD chamber construction » Drift HV to Radiator connection

Home » Alice » Alice TRD chamber construction » Drift HV to Radiator connection

Show: Today's Messages :: Polls :: Message Navigator

Re: Drift HV to Radiator connection [message #1323 is a reply to message #1322]

Tue, 25 January 2005 17:06

Clemens Adler
Messages: 42
Registered: March 2004

continuous participant

From: *kip.uni-heidelberg.de

Hi Chilo,

The only red glue we use is Technicoll 8266/67 which is used for glueing the wires onto the wiring frame. Is there a Problem with that?

Concerning the shocks you got, I'm a bit surprised, I never experienced anything like this. In principle there is (should be) 5 cm of highly isolating material between the drift cathode and the outer surface. I don't know whether there is any likelyhood of this thing charging up over some time. The only thing I could imagine is that maybe somehow the glue would contain too much humidity to allow leak currents, but this would be very unlikely over this distance...
In any case, it will not hurt to put a piece of this 3M copper shielding tape to ground this side.

cheers,
Clemens

Report message to a moderator

[Message index]

		Drift HV to Radiator connection By: Clemens Adler on Thu, 23 September 2004 09:23
		Re: Drift HV to Radiator connection By: Harald Appelshaeuser on Thu, 23 September 2004 11:36
		Re: Drift HV to Radiator connection By: fateev on Mon, 06 December 2004 14:49
		Re: Drift HV to Radiator connection By: Clemens Adler on Mon, 06 December 2004 14:58
		Re: Drift HV to Radiator connection By: Chilo Garabatos on Tue, 25 January 2005 16:42
		Re: Drift HV to Radiator connection By: Clemens Adler on Tue, 25 January 2005 17:06
		Re: Drift HV to Radiator connection By: Chilo Garabatos on Tue, 25 January 2005 17:57
		Re: Drift HV to Radiator connection By: Clemens Adler on Tue, 25 January 2005 18:19
		Re: Drift HV to Radiator connection By: Chilo Garabatos on Mon, 14 February 2005 18:52
		Re: Drift HV to Radiator connection By: Clemens Adler on Tue, 15 February 2005 09:15

Previous Topic:	Anode Wire Problem Summary and Conclusion
Next Topic:	Chamber Construction Manual: new version

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Apr 19 11:02:07 CEST 2024

Total time taken to generate the page: 0.01257 seconds