GSI Forum: Bugs, Fixes, Releases » Error and warning in geometry of MDT and DRC

Home » PANDA » PandaRoot » Bugs, Fixes, Releases » Error and warning in geometry of MDT and DRC

Show: Today's Messages :: Polls :: Message Navigator

Re: Error and warning in geometry of MDT and DRC [message #11728 is a reply to message #11709]

Sun, 01 May 2011 12:09

Maria Patsyuk
Messages: 58
Registered: April 2010

continuous participant

From: *pools.arcor-ip.net

As far as I know the warnings that you get are harmless - they just inform you that Optical Surfaces work only with Geant4 and are ignored if you run the simulations using Geant3. The DIRC geometry and optical photons propagation are not affected by switching between Genat3 and Geant4.

Report message to a moderator

[Message index]

		Error and warning in geometry of MDT and DRC By: Olaf Hartmann on Thu, 21 April 2011 15:55
		Re: Error and warning in geometry of MDT and DRC By: donghee on Thu, 21 April 2011 15:58
		Re: Error and warning in geometry of MDT and DRC By: Olaf Hartmann on Thu, 21 April 2011 16:04
		Re: Error and warning in geometry of MDT and DRC By: donghee on Thu, 21 April 2011 16:07
		Re: Error and warning in geometry of MDT and DRC By: Maria Patsyuk on Sun, 01 May 2011 12:09

Previous Topic:	Gas mixture composition (WMAT).
Next Topic:	Configuring incomplete, errors occurred trunk

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Apr 19 17:43:51 CEST 2024

Total time taken to generate the page: 0.01051 seconds