GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » R3BRoot » General Discussions » new R3B setup components (What are the new R3B setup components?)
new R3B setup components [message #18797] Tue, 01 December 2015 14:07 Go to next message
C. A. Douma is currently offline  C. A. Douma
Messages: 88
Registered: September 2015
Location: Groningen
continuous participant
From: *riken.go.jp
Can anyone tell me which detectors in r3bsim.C belong to the old R3B-LAND setup
and which detectors belong to the new R3B setup at FAIR?

Thanks in advance!
Christiaan Douma
Re: new R3B setup components [message #18798 is a reply to message #18797] Tue, 01 December 2015 15:05 Go to previous messageGo to next message
Dmytro Kresan is currently offline  Dmytro Kresan
Messages: 166
Registered: June 2004
first-grade participant
From: *gsi.de
Hello Christiaan,

There were multiple versions of old LAND set-up. Typical detectors are:

TARGET
ALADIN
CRYSTALBALL
TOF
DCH
TRACKER
LAND


Detectors (and volumes) which definitely belong to new experiments, are:
GLAD
CALIFA
DTOF
STaRTrack
SCINTNEULAND
MFI
PSP

We need to ask Michael for possible corrections.

Best regards,
Dima
Re: new R3B setup components [message #18799 is a reply to message #18798] Tue, 01 December 2015 15:53 Go to previous messageGo to next message
C. A. Douma is currently offline  C. A. Douma
Messages: 88
Registered: September 2015
Location: Groningen
continuous participant
From: *riken.go.jp
Thank you! I will await further information from Michael.

Christiaan.
Re: new R3B setup components [message #18801 is a reply to message #18797] Wed, 02 December 2015 07:58 Go to previous message
Michael Heil is currently offline  Michael Heil
Messages: 4
Registered: July 2015
occasional visitor
From: *gsi.de
Hello Christiaan,
the transition from LAND to R3Broot is floating. Whenever we had a new detector we were using it in the experiment. But I will try to clarify.

TARGET: This is valid for both setups, of course.

ALADIN: Is the old magnet, will be replaced by GLAD.

CRYSTALBALL: is the old gamma calorimeter (and proton detector) will be replaced by CALIFA.

TOF: There are several versions of ToF wall. (TFW, NTF, DTF are old setup. In R3Broot this is called TOF and MTOF.) The new TOF wall is called TOFD and was impemented by Dima as example for the r3broot workshop. It is called DTOF in r3broot.

DCH: This was the first official R3Broot detector. But it arrived at GSI so early that it was used for LAND experiments. In the meanwhile it is already old and will be (probably) not used for FAIR experiment. It will be replaced by straw tubes which are under construction at the moment. Straw tubes are not yet implemented in R3Broot.

TRACKER: This is presumably the proton tracker which surrounds the target. It is not yet finished and will be a FAIR detector.

LAND: Old version of the neutron detector. Will be replaced by NeuLAND. For NeuLAND we were considering two versions, one based on RPC and the other on scintillaotrs and we ran simulations with both. Therefore, you can find several versions. But SCINTNEULAND will be used in future for FAIR.

PSP: Position sensitive pin diodes. Were used in the past for tracking of the incoming beam on target. Will be replaced by strip PSPs in future which are not implemented in R3Broot yet.

GFI: old tracking detectors for fragments. Will be replaced by MFI (thinner fibers).

Best regards,
Michael
Previous Topic: Reading the TTree cbmsim with R3B member functions
Next Topic: Minutes
Goto Forum:
  


Current Time: Sat Dec 14 09:11:37 CET 2024

Total time taken to generate the page: 0.00733 seconds