GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » EMC » barrel geometry in vacuum hits segmentation fault!?
barrel geometry in vacuum hits segmentation fault!? [message #11586] Wed, 16 March 2011 17:21
HosseinMoeini is currently offline  HosseinMoeini
Messages: 10
Registered: May 2007
Location: KVI Groningen
occasional visitor
From: *KVI.nl
Dear all,
Does anybody know why barrel geometry in vacuum results in a segmentation fault error? It appears that it works OK when you set the cave material in pndcave.geo to "air", but emc_complete.C hits a segmentation error when you set the cave material to "vacuum". Interestingly, FwEndCap and BwEndCap work fine with "vacuum"!

Report message to a moderator

Previous Topic: How to get the orientation of a detector element?
Next Topic: readout electronics in geometry
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Sep 10 00:10:01 CEST 2024

Total time taken to generate the page: 0.00671 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software