GSI Forum: EMC » which geometry file?

Home » PANDA » PandaRoot » EMC » which geometry file?

Show: Today's Messages :: Polls :: Message Navigator

which geometry file? [message #11288]

Thu, 09 December 2010 10:13

Olaf Hartmann
Messages: 105
Registered: December 2003
Location: Wien-Alsergrund

continuous participant

From: *smi.oeaw.ac.at

Dear EMC crew,

which geometry do I have to load if I want to get barrel and the endcaps? I tried (from macro/emc/)

Emc->SetGeometryVersion(15);
//new BwEndCap + FwEndCap
Emc->SetGeometryFileNameTriple("emc_module125.dat","emc_module3new.root","em
c_module4_StraightGeo24.4.root");

but I still get only the barrel in the viewer, and also in the list of volumes I don't find the endcap crystals.

Cheers
Olaf.

Report message to a moderator

Re: which geometry file? [message #11289 is a reply to message #11288]

Thu, 09 December 2010 10:17

StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino

first-grade participant

From: *to.infn.it

Hi,
in theory the line with "15" should be enough (check amcro/pid/run_sim_XXX.C). The SetGeometryFiloeNames(XXX) is obsolete and can be removed.

To see EMC you should set a higher visibility level of the TGeoManager -> FAIRGeom->SetVisLevel(10). You can do it easily by TBrowser.

Hope it helps.

Ste

Report message to a moderator

Previous Topic:	Error matrix for EMC
Next Topic:	Removal of Fwd EMC in simulation

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 11 04:44:22 CEST 2024

Total time taken to generate the page: 0.00756 seconds