GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » MVD » Operation of MVD at interaction point
Operation of MVD at interaction point [message #10809] Thu, 17 June 2010 11:46 Go to next message
donghee is currently offline  donghee
Messages: 385
Registered: January 2009
Location: Germnay
first-grade participant
From: *
Dear MVD experts.

I'm wondering about the operational condition of MVD near the interaction and beam pipe region.

Will be cooled inside the beam pipe by cooling system?
or just room temparature in vacuum?
I expect that the MVD itself will operate with some other cooling system and thus keeping much lower temperature.
Could you give me the rough value of expected temperature inside MVD at interation region?


Re: Operation of MVD at interaction point [message #10810 is a reply to message #10809] Thu, 17 June 2010 12:08 Go to previous message
Ralf Kliemt is currently offline  Ralf Kliemt
Messages: 507
Registered: May 2007
Location: GSI, Darmstadt
first-grade participant

From: *
Hello Donghee,

I think your question is not put to the right place, since this is the software forum. However I'll try to answer as much as possible.

To be clear about the design of the MVD I'd like to point to the WiKi:

The Mvd is outside the beam pipe. Housed in Air, not vacuum. There is a cooling system forseen that takes the heat of the forntend electronics away. The Design of the cooling system is under study by now and you can find some information on the Collaboration meeting slides. I take it that you are not present in Stockholm.

Why do you need to know the temperatures?

Kind regards, Ralf.
Previous Topic: Likelihood in PndMvdAdvancedPid Algorithm
Next Topic: Timestamp devlopment
Goto Forum:

Current Time: Tue Jun 25 04:06:02 CEST 2024

Total time taken to generate the page: 0.00861 seconds