GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » CBM » CBMROOT » General » Control of Cuts for Geant4 in CBMRoot
icon5.gif  Control of Cuts for Geant4 in CBMRoot [message #8903] Wed, 24 June 2009 16:13
Andrey Chernogorov is currently offline  Andrey Chernogorov
Messages: 3
Registered: June 2009
occasional visitor

From: *
Hello everyone, I've some problem with usage of Geant4 in CBMRoot.

How I can control cuts for any particles for TGeant4?

Didn't help any changes inside /trunk/gconfig/SetCuts.C
All time Range cuts = 1 mm (or equal in keV).

Didn't help changing: defaultCutValue=1*mm; -> 0.1*mm;
inside /geant4.9.1.p02/source/run/srcG4UserPhysicsList.cxx

When I used /mcPhysics/rangeCut 1 cm in /gconfig/
=> COMMAND NOT FOUND </mcPhysics/rangeCut 1 cm>


As I understand I should change something in/for G4 VMC, but I didn't find it, not yet.

Fanks for any ideas.

[Updated on: Wed, 24 June 2009 16:33]

Report message to a moderator

Previous Topic: Usage of Geant4 in CBMRoot
Next Topic: Moving the Geometry from data file to the parameters
Goto Forum:

Current Time: Mon Jul 15 12:58:44 CEST 2024

Total time taken to generate the page: 0.00640 seconds