GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » Tracking » Error calculation in Kalman Filter
Error calculation in Kalman Filter [message #7966] Fri, 27 February 2009 22:33 Go to next message
Anonymous Poster From: *pool.einsundeins.de
Hi everybody,

something about the Kalman filter came to my attention: We are fotting the same track several times in the Kalman filter. This is to reduce biasing of the results due to wrong starting values (which is to some extend unavoidable). This procedure however will lead to wrong errors on the track parameters. When I fit a track n times, the error will be 1/sqrt(n) times what it should be. All the information has been used n times. To avoid this we need to blow up the covariance matrix, before the repeated fitting. Maybe this might even make things a bit more stable, although I doubt that.

Does anybody use the errors on the track parameters (and for that matter on the position and the momentum) after GenFit? If so, your results are subject to smaller errors.

I think this should be changed in principle. I cant volunteer at this point to do it (and most importantly test it), but I wanted to bring it to attention. I am very caught up in COMPASS data analysis these days. Before that I rebuilt and upgraded the small TPC prototype and worked on the test beam. These are the main reasons, why my contributions to PANDAROOT are much less than before.

My first approach would be this: Before changing direction after one full pass, one should drop all off-diagonal entris of the covariance and multiply the diagonal elements with a large factor (10 or so). That should do it.


Have a nice weekend!

Christian
Re: Error calculation in Kalman Filter [message #7967 is a reply to message #7966] Fri, 27 February 2009 23:16 Go to previous message
Bertram Kopf is currently offline  Bertram Kopf
Messages: 110
Registered: March 2006
continuous participant
From: *pools.arcor-ip.net
Hi Christian,

Christian Hoeppner wrote on Fri, 27 February 2009 22:33


Does anybody use the errors on the track parameters (and for that matter on the position and the momentum) after GenFit? If so, your results are subject to smaller errors.



The errors of the track parameters are one of the most important input for the kinematic and vertex fitters used in the analysis part. For this it must be to guaranteed that the errors are correct. If not it could lead to completely wrong results.

Have a nice weekend,
Bertram.
Previous Topic: B field scaling for PANDA
Next Topic: GenFit cleanup
Goto Forum:
  


Current Time: Sun Dec 08 16:48:43 CET 2024

Total time taken to generate the page: 0.00681 seconds