GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » Controls » SCADA systems » DIM interface for LabVIEW
DIM interface for LabVIEW [message #403] Fri, 30 April 2004 17:53 Go to next message
Dietrich Beck is currently offline  Dietrich Beck
Messages: 1
Registered: April 2004
Location: GSI-Darmstadt
occasional visitor
From: depc122.gsi.de
Hello,

DIM is a communication system for distributed / mixed environments. It provides a network transparent inter-process communication layer and is a light protocol with high performance based on TCP/IP. DIM has been developed at CERN and is available for Linux, Unix, Linux, Windows, OS9, LynxOS and VxWorks. Available interfaces are Fortran, C and C++. For more information about DIM see http://dim.web.cern.ch/dim/.

I have developed a DIM interface of LabVIEW that is based on the official DIM distribution. By this, LabVIEW can be linked to all platforms supported by DIM.

The LabVIEW interface is available under the terms of the GPL. It can be downloaded from http://www-w2k.gsi.de/labview/driver.htm#Communication%20Drivers.

Regards,

Dietrich
Re: DIM interface for LabVIEW [message #485 is a reply to message #403] Tue, 18 May 2004 10:13 Go to previous message
Herbert Pichlik is currently offline  Herbert Pichlik
Messages: 189
Registered: January 2004
first-grade participant

From: 62.146.53*
Hallo Dietrich,
kannst Du bei der LabVIEW Usergroup Hauptversammlung
einen Kurzvortrag über Deine Applikationen machen?
Ich denke, dass neben der Führung durch Holger (?) und den sehr trockenen Themen (z.B. Entlastung des Schatzmeisters) etwas Auflockerung notwendig ist.
Herzliche Grüße
Herbert
Next Topic: EPICS & LabVIEW
Goto Forum:
  


Current Time: Wed Oct 16 02:53:31 CEST 2024

Total time taken to generate the page: 0.00697 seconds