GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » EMC » which geometry file?
which geometry file? [message #11288] Thu, 09 December 2010 10:13 Go to next message
Olaf Hartmann is currently offline  Olaf Hartmann
Messages: 105
Registered: December 2003
Location: Wien-Alsergrund
continuous participant
From: *smi.oeaw.ac.at
Dear EMC crew,

which geometry do I have to load if I want to get barrel and the endcaps? I tried (from macro/emc/)

Emc->SetGeometryVersion(15);
//new BwEndCap + FwEndCap
Emc->SetGeometryFileNameTriple("emc_module125.dat","emc_module3new.root","em
c_module4_StraightGeo24.4.root");


but I still get only the barrel in the viewer, and also in the list of volumes I don't find the endcap crystals.

Cheers
Olaf.
Re: which geometry file? [message #11289 is a reply to message #11288] Thu, 09 December 2010 10:17 Go to previous message
StefanoSpataro is currently offline  StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino
first-grade participant

From: *to.infn.it
Hi,
in theory the line with "15" should be enough (check amcro/pid/run_sim_XXX.C). The SetGeometryFiloeNames(XXX) is obsolete and can be removed.

To see EMC you should set a higher visibility level of the TGeoManager -> FAIRGeom->SetVisLevel(10). You can do it easily by TBrowser.

Hope it helps.

Ste
Previous Topic: Error matrix for EMC
Next Topic: Removal of Fwd EMC in simulation
Goto Forum:
  


Current Time: Thu Jul 25 14:21:10 CEST 2024

Total time taken to generate the page: 0.00895 seconds