GSI Forum: EMC » barrel geometry in vacuum hits segmentation fault!?

Home » PANDA » PandaRoot » EMC » barrel geometry in vacuum hits segmentation fault!?

Show: Today's Messages :: Polls :: Message Navigator

barrel geometry in vacuum hits segmentation fault!? [message #11586]

Wed, 16 March 2011 17:21

HosseinMoeini
Messages: 10
Registered: May 2007
Location: KVI Groningen

occasional visitor

From: *KVI.nl

Dear all,
Does anybody know why barrel geometry in vacuum results in a segmentation fault error? It appears that it works OK when you set the cave material in pndcave.geo to "air", but emc_complete.C hits a segmentation error when you set the cave material to "vacuum". Interestingly, FwEndCap and BwEndCap work fine with "vacuum"!

Report message to a moderator

[Message index]

barrel geometry in vacuum hits segmentation fault!?

By: HosseinMoeini on Wed, 16 March 2011 17:21

Previous Topic:	How to get the orientation of a detector element?
Next Topic:	readout electronics in geometry

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon May 25 10:36:38 CEST 2026

Total time taken to generate the page: 0.00801 seconds