GSI Forum: General » How to get the list of Volumes?

Home » PANDA » PandaRoot » General » How to get the list of Volumes?

Show: Today's Messages :: Polls :: Message Navigator

How to get the list of Volumes? [message #11230]

Wed, 24 November 2010 09:40

Olaf Hartmann
Messages: 105
Registered: December 2003
Location: Wien-Alsergrund

continuous participant

From: *smi.oeaw.ac.at

Dear all,

I'm searching for a possibility to print the list of volumes in a simulation run, something like the "dtree" command in Geant3. So far I found the number of volumes and the number of daughter volumes, but hopefully there's an easier way.

Any hint?

Cheers
Olaf.

Report message to a moderator

[Message index]

		How to get the list of Volumes? By: Olaf Hartmann on Wed, 24 November 2010 09:40
		Re: How to get the list of Volumes? By: Mohammad Al-Turany on Fri, 26 November 2010 13:30
		Re: How to get the parameters of Volumes? By: Olaf Hartmann on Mon, 13 December 2010 09:58
		Re: How to get the parameters of Volumes? By: Tobias Stockmanns on Mon, 13 December 2010 10:27
		Re: How to get the parameters of Volumes? By: Olaf Hartmann on Mon, 13 December 2010 10:42
		Re: How to get the parameters of Volumes? By: Ralf Kliemt on Mon, 13 December 2010 16:01
		loading complete geometry By: Olaf Hartmann on Fri, 03 December 2010 14:29
		Re: loading complete geometry By: StefanoSpataro on Fri, 03 December 2010 21:21

Previous Topic:	TRAC ticketing system
Next Topic:	PndEventReader

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed May 20 06:35:33 CEST 2026

Total time taken to generate the page: 0.00726 seconds